Pole Mounting Hardware Instructions

1. Cut strapping to desired length. Be sure you have enough length to go around the pole and still have enough to feed through the U-TS1 bracket

2. Feed strapping through the U-TS4 bracket.

3. Feed ends of strapping through each half of the U-TS1 bracket and bend strapping over to lock in place

4. Place assembly around the pole to check the length. Adjust as necessary. Insert bolt through each half of the U-TS1 bracket and tighten nut to lock in place.

5. Put sign flat against the U-TS4 bracket and insert bolt through the top hole in the sign and thread the bolt into the bracket.

Repeat the steps above for the bottom hole of the sign.